Commax Dp-ra01 Installation Manual __link__ Jun 2026

Follow these steps to install your Commax DP-RA01 intercom. The process is broken down into physical mounting, wiring, and final checks.

2-wire connection to the outdoor door camera/unit; 2-wire connection to the electric door strike (optional). Mounting Type: Surface wall-mount.

Comprehensive Commax DP-RA01 Installation Manual: Guide to Installation and Wiring The Commax DP-RA01 commax dp-ra01 installation manual

The Commax DP-RA01 is an audio intercom (a "tubo" or "unifon" in various markets). It is designed for simple and reliable two-way communication. Understanding its core specifications is the first step to a successful installation.

The sub-station and door station are typically powered directly by the master station and do not need separate power cords. System Configuration & Distance Maximum Distance : 100m using the empty set 0.65 m m copper wire or 150m using the empty set 0.8 m m copper wire. Follow these steps to install your Commax DP-RA01 intercom

Connect to the door station (2-wire connection) for communication.

: Plug the power cord into a standard AC outlet after all signal wiring is secure. Technical Specifications Power Source AC 100-240V, 50/60Hz Wiring 2 wires to door camera; 2 wires to door release Compatibility Mounting Type: Surface wall-mount

Tighten any small retaining locking screws located at the bottom edge of the device if applicable. System Testing and Calibration

The indoor monitor is the second component to install. Follow these steps:

Insert the wires into their respective screw terminals based on your building's wiring schema.