V2000-c Rfid Access Control User Manual
The V2000-c allows card+PIN or PIN-only access.
| Action | Command | |--------|---------| | Enter programming mode | *MasterCode# (e.g., *123456# ) | | Change master code | 00 NewCode# RepeatNewCode# | | Add RFID card | 11 CardNumber# (or present card after 11 ) | | Add PIN user (ID 1–200) | 12 UserID# PIN# | | Add card + PIN user | 13 UserID# → present card → enter PIN | | Delete single user | 14 UserID# | | Delete all users | 15# (use with caution) | | Set relay duration (1–60s) | 03 Seconds# | | Set door sensor mode (0=off,1=on) | 04 Mode# | | Exit programming | *# |
Ensure you are in Programming Mode before executing these commands. : Press 1 ➔ Swipe the RFID Card ➔ Press # . Add Card User by Specific ID Slot : V2000-c Rfid Access Control User Manual
The connector is a dry contact relay for the lock. You can set its normal state using the J1 jumper.
This manual serves as a definitive resource for physical setup, initial programming, wiring layouts, and regular administration. Users looking to save a copy can access the official Obohands V2000-C Product Downloads for direct digital documentation. 1. Technical Specifications and Hardware Overview The V2000-c allows card+PIN or PIN-only access
If you forget the Master Code or experience configuration errors, perform a hard factory reset. the V2000-C unit.
The V2000-C is a "Standalone" unit, meaning it does not require a constant network connection to work, but it can connect for management. Add Card User by Specific ID Slot :
If you need specific wiring diagrams, reset instructions, or advanced features (like anti-passback or time schedules), please provide the exact or brand label from your device.
To perform any administrative tasks, you must first enter .
Press 4 ➡️ 1 ➡️ #
