For further assistance, please consult the following resources:
A: Not directly. Bafang uses UART protocol. KT displays only work with KT controllers.
A: Check P2 setting. For external speed sensor, ensure magnet passes sensor within 5mm. Kt 70 Installation Manual
The (Manufacturer Document Number: 006-00673-0001 ) is the authoritative technical reference required to safely mount, wire, configure, and certify the BendixKing KT 70 Mode S ATC Transponder . As a foundational panel-mounted unit in the classic Silver Crown series, the KT 70 relies heavily on strict adherence to its installation specifications to ensure proper Air Traffic Control Radar Beacon System (ATCRBS) and Mode S communication.
The KT 70 provides essential Mode S capabilities, including enhanced surveillance and Altitude Encoding. Unlike older Mode C transponders, the KT 70 offers: A: Check P2 setting
Check for shorts or open circuits in the antenna cable.
Ensure all ground pins are securely connected to the airframe ground to reduce electrical noise. 5. Configuration and Post-Installation Checkout As a foundational panel-mounted unit in the classic
The KT 70 accepts both traditional parallel Gillham gray code and serial data protocols for altitude inputs. Gillham (Gray Code) Connection
Before beginning the installation, you must consult the official KT 70 Installation Manual for the most up-to-date, specific instructions.
Do not overtighten; stop when the unit is firmly seated against the bezel. 2. Electrical Wiring & Pinout Configuration
: Standard RG-58 cable is generally insufficient for long runs due to high signal attenuation. The installation manual dictates low-loss coaxial alternatives (e.g., RG-400 or specialized electronic cables) to ensure total signal attenuation does not exceed the maximum allowable 2.0 dB loss limit .